Table of Contents
Advertisement
KTD-N0903-C
Audio
Audio, 7.1 Channel High Definition Audio Codec using the VIA VT1708S codec.
•
Line-in (Blue Jack connector).
•
Headphone stereo signals. (Shared Lime Jack and pin-row connector).
•
Headphone stereo signals. (Front Panel connector).
•
Microphones: MIC1 (MIC connector) and MIC2 (Front Panel connector).
•
SPDIF-Out (electrical Interface only).
•
On-board speaker (Electromagnetic Sound Generator like Hycom HY-05LF).
Expansion
•
1x 1x mPCIe (w. USB2.0 and SIM card slot) (Shared with mSATA)
•
1x PCIe x1
Capabilities
•
SPI bus routed to SPI connector (BIOS Recovery module interface)
•
DDC/AUX Bus routed to DP connector (Auto detect to DDC when using passive DP
to HDMI or DVI adapters)
Via Feature connector based on ITE IT8516E Embedded Controller via LPC Bus interface
•
SMBus, compatible with ACCES BUS and I2C BUS
•
18 x GPIOs (General Purpose I/Os)
•
DAC, ADC, PWM and TIMER (Multiplexed)
•
WAKE UP / Interrupt Inputs (Multiplexed)
•
3 Wire Bus for GPIO Expansion (up to 152 GPIOs)
•
8 bit Timer output
Hardware
•
Fan control support Speed cruise.
•
Thermal inputs: PCB near SOC temperature (precision +/- 3ºC).
Monitor
•
System temperature sensor (precision +/- 0.5ºC)
Subsystem
•
Sleep S5# Indication, (via Feature connector)
•
System Powergood Signal, (via Feature connector)
Security
Integrated TPM 1.2 support. E3845 only.
Power Supply
+12V single supply via either Vin-Int. (4-pin connector) or Vin-Ext. connector (DC
Connector RA 2mm locking type)
Unit
Battery
Exchangeable 3.0V Lithium battery for on-board Real Time Clock and CMOS RAM.
Manufacturer Panasonic / Part-number CR-2032L/BN, CR2032N/BN or CR-2032L/BE.
Approximate 6.2 years retention.
Current draw is less than 4.2µA when PSU is disconnected and 0 µA in S0 – S5.
Note that Intel specifies that battery must be connected, however it is unspecified what
is the risk of not using battery. When battery is not connected, Kontron has not been
able to find any problems except for RTC not running.
CAUTION: Danger of explosion if the battery is incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer. Dispose of
used batteries according to the manufacturer's instructions.
OS support
Windows 7 (32 and 64bit) and Windows 8 (32 and 64bit)
(planned)
Windows Embedded 7 and Windows Embedded 8
Linux
WxWorks
Page 9
mITX-E38 Users Guide
System Specification
Advertisement
Table of Contents
