Table of Contents
Advertisement
KTD-N0903-C
Function
System Temperature Ext Type
Fan Cruise Control
(System)
Fan Settings
(System)
Fan Min limit
(Note 4)
(System)
Fan Max limit
(Note 4)
(System)
Fan Cruise Control
(CPU)
Fan Settings
(CPU)
Watchdog Function
Note 1: When not Disabled then the System Temperature readout will only be valid if the sensor is physically
connected to the Feature connector.
Note 2: ºC (if Fan Cruise Control is Thermal) then use either digit keys to enter value or +/- keys to
increase/decrease value. Don't use mix of digit keys and +/- keys.
Note 3: RPM (if Fan Cruise Control is Speed) use either digit keys to enter value or +/- keys to
increase/decrease value by 100. Don't use mix of digit keys and +/- keys.
Note 4: Only visible if Fan Cruise Control is Thermal.
Note5: Use number keys to enter value.
Note 6: Seconds, use digit keys to enter value. Value 0 means Watchdog is disabled. Refer to "KT-API-V2
User Manual" to control the Watchdog via API or refer to "KT-API-V2 User Manual DLL" how to control
Watchdog via Windows DLL.
Page 54
Selection
Disabled
(Note 1)
LM75 @ 0x90
OneWire @ GPIO16
Disabled
Thermal
Speed
30 – 90
(note2)
1000 – 10000 (note3)
0
(note5)
100
(note5)
Disabled
Speed
1000 – 10000 (note3)
0 - 255
(note6)
mITX-E38 Users Guide
Description
Use external connected sensor instead of
onboard.
Disabled = Full speed.
Thermal: Regulate according to specified ºC.
Speed: Regulate according to specified RPM.
Minimum PWM %, can be used to make sure
fan is always active. Make sure Min limit <
Max limit.
Maximum PWM %, can be used to limit the
fan noise. Make sure Min limit < Max limit.
Disabled = Full speed.
Speed: Regulate according to specified RPM.
0 = Disabled.
Enter the service interval in seconds before
system will reset.
BIOS - Advanced
Advertisement
Table of Contents
