Requirements Iec60950 - Kontron mITX-E3815 User Manual

KTD-N0903-C
8. Mounting the board in chassis
Warning: When mounting the board to chassis etc. please notice that the board contains
!
components on both sides of the PCB which can easily be damaged if board is handled without
reasonable care. A damaged component can result in malfunction or no function at all.
When fixing the Motherboard on a chassis it is recommended using screws with integrated washer and a
diameter of ⋲7mm. Do not use washers with teeth, as they can damage the PCB and cause short circuits.

Requirements IEC60950

2.2
Take care when designing chassis interface connectors in order to fulfil the IEC60950 standard.
When an interface or connector has a VCC (or other power) pin which is directly connected to a power plane
like the VCC plane:
To protect the external power lines of the peripheral devices the customer has to ensure:
• Wires have suitable rating to withstand the maximum available power.
• That the enclosure of the peripheral device fulfils the fire protecting requirements of IEC60950.
CAUTION!
Danger of explosion if battery is incorrectly re- placed.
Replace only with same or equivalent type recommended
by manufacturer. Dispose of used batteries according to
the manufacturer's instruc- tions.
ATTENTION!
Risque d'explosion avec l'échange inadéquat de la
batterie. Remplacement seulement par le même ou un
type équivalent recommandé par le producteur.
L'évacuation des batteries usagées conformément à des
indications du fabricant.
ADVARSEL!
Lithiumbatteri – Eksplosionsfare
håndtering. Udskiftning må kun ske med batteri af
samme fabrikat og type. Levér det brugte batteri tilbage
til leverandøren.
VARNING!
Explosionsfara vid felaktigt batteribyte. Använd samma
batterityp eller en ekvivalent typ som rekommenderas av
apparattillverkaren. Kassera använt batteri enligt
fabrikantens instruktion.
Page 7
Lithium battery precautions
Explosionsgefahr bei unsachgemäßem Austausch der
Batterie. Ersatz nur durch den selben oder einen vom
Hersteller
Entsorgung gebrauchter Batterien nach Anga- ben des
Herstellers.
Peligro de explosión si la batería se sustituye
incorrectamente. Sustituya solamente por el mismo o
tipo equivalente recomendado por el fabricante.
Disponga las baterías usadas según las instrucciones
del fabricante.
ved fejlagtig Eksplosjonsfare ved feilaktig skifte av batteri. Benytt
samme batteritype eller en tilsvarende type anbefalt av
apparatfabrikanten.
henhold til fabrikantens instruksjoner.
Paristo voi räjähtää, jos se on virheellisesti asennettu.
Vaihda
suosittelemaan tyyppiln. Hävitä käytetty paristo
valmistajan ohjeiden mukaisesti.
mITX-E38 Users Guide
Installation Procedure
VORSICHT!
empfohlenen gleichwertigen
PRECAUCION!
ADVARSEL!
Brukte batterier kasseres i
VAROITUS!
paristo ainoastaan lalteval-
Typ.
mistajan