Table of Contents
Advertisement
SOFTWARE CONFIGURATION STRINGS
Command Syntax
The command syntax is given below with an example:
Command(s)
$+
The new setting will be definitive (stored in FLASH EPROM)
Example:
Multiple command programming sequence:
$+
BK0
CD7
Enter configuration environment
Each configuration parameter setting removes the condition previously active for that
parameter.
The device buffer can contain about 400 characters. If your
programming string goes over this value, you must split it into separate
groups and send each group after a delay of at least 3 seconds to give
the reader time to empty the buffer and interpret the commands.
NOTE
$-
<CR>
AC410132
$-
Matrix 2/5 3 bars: no check digit,
variable length code from 1 to 32 characters
Baud rate = 19200
Serial On-Line operating mode
CR
Carriage return character (0D Hex.)
Exit and save new configuration
3
23
Advertisement
Table of Contents
