Settings; Dhcp Ip Address; Static Ip Address - HP R110 Configuration And Administration Manual

DDNS
The status of a dynamic DNS service.
MAC Clone
Indicates if the WAN port MAC address has been copied from a LAN computer.

Settings

The WAN settings page configures the method that the router uses to connect to an ISP through
the WAN port. The router supports five Internet connection methods.

DHCP IP address

A dynamic connection type is the most common method used with cable modems. In many
cases, setting the connection type to dynamic is enough to complete the connection to your ISP.
Some dynamic connection types may require a Host Name. Enter the Host Name in the space
provided if you were assigned one by your ISP (do not use characters ` " & ' # \).
Some dynamic connections require that you clone the MAC address of the PC that was
originally connected to the modem. To do so, click on WAN > MAC Clone to set the WAN
MAC address. For more information, see
This page includes the following information:
Connection Type
Select DHCP as the router's method of connecting to the ISP.
Host Name
The host name of the DHCP client. The host name is optional, but may be required by some
ISPs.
Primary/Secondary DNS Address
The IP addresses of primary and secondary domain name servers.

Static IP address

The Static IP address mode sets the router to operate with a fixed IP address to connect to the
Internet. If your ISP uses static IP addressing, you need an IP address, subnet mask, and ISP
gateway address. This information is available from your ISP or on the paperwork that your ISP
left with you. Enter your information in the provided spaces, and then click Save.
36 WAN configuration
"MAC clone" on page 42.