Lan Settings; Default Vlan Settings - HP R110 Configuration And Administration Manual

This page includes the following information:
LAN
Displays current settings for the default VLAN.
•
MAC address: The Ethernet base MAC address of the router.
•
IP address: The IPv4 address of the router.
•
Subnet mask: The subnet mask for the IP address.
•
DHCP Server: The status of the DHCP server for the default VLAN.
•
IGMP Proxy: The status of the IGMP Proxy feature for the default VLAN
•
IGMP Snooping: The status of the IGMP Snooping feature for the default VLAN
STP
Displays Spanning Tree Protocol information.
•
Version: Indicates if the Spanning Tree Protocol (STP) or Rapid Spanning Tree Protocol
(RSTP) are enabled for the default VLAN.
•
Root Port: The port on the router that is connected to the Spanning Tree root device. If
there is no root port, then this router has been accepted as the root device of the Spanning
Tree network.
•
Root MAC Address: The MAC address of the root device in the Spanning Tree network.
•
LAN1–LAN4: Displays the state of the router's port interfaces in the Spanning Tree
network; Disabled, Learning, Forwarding, or Blocking.
VLAN
The table includes all VLANs currently configured on the router.

LAN Settings

The router must have a valid IP address for management using a web browser and to support
other features. The router has a default IP address of 192.168.1.1. You can use this IP address or
assign another address that is compatible with an existing local network.

Default VLAN settings

The IP Address on the Settings page is the IP address of the default VLAN. To access the web
interface, enter this IP address into the address bar of your web browser. This address can be
changed if needed. To change the IP address, enter the new IP address and click Save. The IP
address you choose should be a private IP.
Examples of a private IP are:
192.168.x.x (where x is anything between 0 and 255)
10.x.x.x (where x is anything between 0 and 255)
44 LAN configuration