Wmm Settings - HP R110 Configuration And Administration Manual

Enter the 8-digit PIN number and click Start to activate the PIN method. If the WPS
function is working correctly, you should see the WPS LED light up.
•
PBC: Uses the push-button method. Make sure the WPS function has been enabled on the
device. On the client side, start the WPS utility that is provided by your Wi-Fi card's vendor
and select the PBC method. Follow the instruction of your WPS utility. Push the WPS button
on the router; the WPS LED begins blinking. While the LED is blinking, do not push the
button again. If the WPS function is working correctly, the WPS LED lights up.
Status
Displays the following WPS status information:
•
WPS Status: Displays the WPS configured state.
•
Lock Status: Displays the PIN lock function state.
•
Self PinCode: The PIN code of the router.
•
SSID: The SSID of the router's primary VAP interface.
•
Authentication Mode: The wireless security mode being used by WPS.
•
Pre-shared Key: The security key being used by WPS.

WMM settings

Wi-Fi Multimedia (WMM) is a Wi-Fi Alliance interoperability certification based on the IEEE
802.1 1e draft standard. WMM provides basic Quality of service (QoS) features for IEEE 802.1 1
networks. WMM prioritizes traffic according to four Access Categories (AC), however it does
not provide guaranteed throughput. It is suitable for simple applications that require QoS, such
as Wi-Fi Voice over IP (VoIP) phones.
This page includes the following settings.
Enable WMM
Select the checkbox to enable the WMM QoS features on the router.
68 Wireless configuration