Pppoe - HP R110 Configuration And Administration Manual

VLAN (Default) Settings
Sets the IPv6 settings for the local VLAN.
•
Enable DHCP-PD: Enables the Prefix Delegation feature that automatically uses an IPv6
prefix for the local LAN defined by the ISP. When disabled, the IPv6 address and prefix
length need to be manually defined.
•
Auto Configuration: Select Stateless (RADVD) or Stateful (DHCPv6).
•
Lifetime: The time that the IPv6 address assignment is valid.

PPPoE

If your ISP uses Point-to-Point Protocol over Ethernet (PPPoE) as the IPv6 connection type, enter
the PPPoE information in the provided spaces, and then click Save to activate your setting.
This page includes the following settings:
Connection Settings
Sets basic IPv6 address configuration settings.
•
IPv6 Connection: Select PPPoE for the IPv6 address connection mode.
110 IPv6 configuration
•
IPv6 Address: The IPv6 address of the router for the local LAN.
•
Subnet Prefix Length: The prefix length of the IPv6 address.
•
Disable: Disables the automatic assignment of IPv6 addresses to local hosts.
•
Stateless (RADVD): Enables the automatic assignment of IPv6 addresses by hosts on
the local network. The network portion of the address is based on prefixes received in
IPv6 router advertisement messages, and the host portion is automatically generated
using the modified EUI-64 form of the client identifier (that is, the client MAC address).
•
Stateful (DHCPv6): Enables DHCPv6 automatic assignment of IPv6 addresses to
local hosts based on a defined address pool. Enter the start and end of the address
range to define the pool.