Ipv6 Settings; Static Ipv6 - HP R110 Configuration And Administration Manual

DHCP-PD
The status of the DHCPv6 Prefix Delegation feature.

IPv6 settings

The router supports static, stateless address autoconfiguration (SLAAC), DHCPv6, and PPPoE
modes for IPv6 settings for the WAN port. Select the method to use as instructed by your ISP,
and then enter the required information and click Save.

Static IPv6

The Static IP addresses mode sets the router to operate with a fixed IP address to connect to the
Internet. If your ISP uses static IP addressing, you need an IP address, subnet mask, and ISP
gateway address. This information is available from your ISP or on the paperwork that your ISP
left with you.
This page includes the following settings:
Connection Settings
Sets basic IPv6 address configuration settings.
•
IPv6 Connection: Select Static for the IPv6 address connection mode.
•
IPv6 Address: The IPv6 address of the router. IPv6 addresses are 16 bytes long (128
bits), written as eight groups of hexadecimal quartets separated by colons. The initial bits
in an IPv6 address represent the network prefix and are the same for all devices in the
network. For example, an IPv6 address could be written as
2001:adca:0000:0000:0000:0000:123a:4567. Note that one double colon may be used
in the address to indicate the appropriate number of zeros required to fill the undefined
106 IPv6 configuration