Setting The Page Margins - Roland FJ-42 User Manual

Setting the Page Margins

This makes the setting for the margin between pages.
When outputting a number of pages continuously, you can establish a margin between the pages.
You can set this in a range of 0 mm to 100 mm (in 10-mm steps).
This is set at 10 mm when shipped from the factory.
Start of the next printing operation
End of printing
Margin (value set for [PAGE MARGIN])
1
Press the [MENU] key and [
following screen appear on the display.
3
Use the [ ] and [
the [ENTER] key.
PAGE MARGIN
10mm 20mm
0 to 100 mm
(In steps of 10 mm)
- When separating the material with the margin set at [0], the position where the material is separated and the end of
printing may not match.
- When performing continuous printing with the margin set at [0], image quality just after starting to print may be
poor on the second page or after. Also, dot drop-out or overlap may occur at the page borders.
10 mm (3/8 in.)
] key to make the
MENU
PAGE MARGIN
] keys to set a margin, then press
Start of the next printing operation
End of printing
Location where separated
Margin (value set for [PAGE MARGIN])
[When the material-cutting command is enabled]
2 Press the [ ] key to make the following screen
appear on the display.
2 Basic Operation
10 mm
(3/8 in.)
10 mm (3/8 in.)
PAGE MARGIN
10mm 10mm
37