Front Panel (Alg) Block, Fuse (F902) - Sony HAP-S1 Service Manual

HAP-S1
2-3.

FRONT PANEL (ALG) BLOCK, FUSE (F902)

2 four screws
(BTP3
5 Remove the front panel (ALG) block
in the direction of an arrow.
9 front panel (ALG) block
6 flexible flat cable (17P)
(CN5010)
Note 2: When installing the flexible flat cable,
ensure the colored line.
No slanting after insertion.
flexible flat cable
colored line
connector
10
6)
– Rear bottom view –
3 claw
7 flexible flat cable (40P)
(CN001)
Note 1: Please spread a sheet under
1 two screws
(BV3)
3 claw
8 connector
(CN2001)
Note 3: When installing the front panel (ALG) block,
check that the GND plates (AL) are not
damaged and being installed.
a unit not to panel.
4 Remove the front panel (ALG) block
in the direction of an arrow.
– Rear view –
ire etti
clamp
front side
HP board
0 fuse (F902)