Hdd (Hdd1); Ant Holder Block (Right Side) - Sony HAP-S1 Service Manual

2-11. HDD (HDD1)

Note 1: When the hard disk drive (Ref. No. HDD1) is replaced,
refer to "NOTE OF REPLACING THE HARD DISK
DRIVE (Ref. No. HDD1)" on page 4.
DCDC board
3 HDD connector
HDD (HDD1)
4 HDD connector
(15 pins)

2-12. ANT HOLDER BLOCK (RIGHT SIDE)

2 Remove the ANT holder block (right side)
in the direction of an arrow.
7 HDD (HDD1)
(7 pins)
6 bracket
(HDD)
3 three claws
6 bracket (HDD)
5 four screws (PSW3
Note 2: No problem using the electric screwdriver
2 Remove the HDD block in
the direction of an arrow.
1 two step screws
4 ANT holder block (right side)
5)
when installing or removing these screws.
When tightening screws, tighten the below
torque value.
tightening torque: . .
1 two step screws
1 flat screw
HAP-S1
N m
15