5-Inch Viewfinder Attachment - Hitachi SK-HD1500-S2 Operating Instructions Manual

5-inch viewfinder attachment

5-inch viewfinder attachment
Use the separately sold AT-500 viewfinder adapter when installing the VF-HD500 5-inch viewfinder.
Installation
1. Raise the lock lever of the AT-500 horizontally and remove the viewfinder mounting screw from the
AT-500. Insert this screw in the bottom of the viewfinder. Insert the screw together with the
viewfinder into the AT-500 and set the lock lever forward, then turn the lever clockwise to secure it.
Be sure to tilt the lock lever forward and turn it clockwise to tighten it.
If tightening is overlooked, the viewfinder can drop and pose a risk of injury.
2. Insert the viewfinder and AT-500 into the slot at the rear of the handle and slide them forward until
a latching sound is heard from the release knob.
Be sure to tilt the lock lever forward and turn it clockwise to tighten it.
If tightening is overlooked, the viewfinder can drop and pose a risk of injury.
Set lock lever B of the AT-500
rearward.
Removal
Disconnect the viewfinder cable. Turn the AT-500 lock
lever B counter-clockwise and pull the release knob to
allow removing both the viewfinder and AT-500.
lock lever A
lock lever B
Connect the viewfinder cable to the
camera viewfinder connector.
18