Ignition Coil - Rxl-40; Ignition Timing; Safety Remote Controller And Controller Receiver - Eton America Rascal IXL-40 Service Manual

11.2 IGNITION COIL - RXL-40

Remove the spark plug cap from the spark plug.
Disconnect the ignition coil primary wire.
Measure the primary coil resistance.
STANDARD:
0.1 - 0.3-(20)
Measure the secondary coil resistance with the spark
plug cap in place.
STANDARD:
7.4 - 11 k(20)

11.3 IGNITION TIMING

The ignition advance is 1
The Capacitive Discharge Ignition (CDI) system is fac-
tory pre-set and does not require adjustment.
11.4 SAFETY REMOTE CONTROLLER &
CONTROLLER RECEIVER
The controller has a maximum effective distance of 30
ft To maintain the effective distance of the controller,
the batteries must be kept at or near full charge.
Check battery charge level before each use and replace
when charge becomes low.
Remove batteries from both the transmitter and
receiver if unit will not be used for an extended
period of time.
The standard battery is 12V 23A.
The controller receiver battery is located under the
seat. USE ONLY Alkaline batteries (4 * AA) in the
receiver.
5°± 3°/4000rpm
ELECTRICAL SYSTEM