Remove the cylinder.
5.2 INSPECTION
Inspect the cylinder bore for wear or damage.
Measure he cylinder inner diameter at three levels in an X
and Y axis. Calculate cylinder taper at three levels in an X
and Y axis.
Take the maximum reading to determine the taper.
TAPER LIMIT : 0.01mm
Calculate the cylinder out-of-round at three levels in the X
and Y-axis. Take the maximum reading to determine the
out-of-round. Out OF ROUND: 0.10mm
5.3 PISTON REMOVAL
Remove the piston pin clips with needle nose pliers.
NOTE: Don't allow the clips fall into the crankcase.
Press the piston pin out of the piston.
5-2