Engine Removal And Installation - Eton America Rascal IXL-40 Service Manual

3. ENGINE REMOVAL AND INSTALLATION

3.1 ENGINE REMOVAL
Remove the seat and the Body Cover. (chapter 10)
Remove the spark plug cap from the spark plug.
Remove the exhaust pipe.
Remove the air cleaner and carburetor Remove the
throttle cable and fuel lines.
Disconnect the wire connectors and remove the wire
from the frame clamps.
Remove the chain protection cover.
Remove the drive chain retaining clip and master link, and
remove the drive chain.
Remove the lower engine hanger nuts and the lower
mission case hanger bolt at the right side.
Remove the engine from the left side.
3.2 ENGINE INSTALLATION
Engine installation is essentially the reverse order of
removal. The torque of engine hanger bolt is 24-30 Nm
Route the wires and cable in reverse order properly.
3-1