Carburetor Removal; Floats, Float Valve And Jets Assembly - Eton America Rascal IXL-40 Service Manual

4.5 CARBURETOR REMOVAL

Loosen the drain screw and drain the gasoline. Remove
the float chamber by removing the two retaining
screws.
Remove the float arm pin.
Remove the float and float valve.
Inspect the float valve for wear or damage.
Remove the main jet and needle jet.
Blow open all jets and body openings with compressed
air.
Inspect the needle jet and main jet.
Check each part for wear or damage.
Clean the passages and jets with compressed air.
4.6 FLOATS, FLOAT VALVE, AND JETS
ASSEMBLY
NOTE:
Handle all jets and needles with care. They can be easily
scored or scratched.
Install the needle jet, main jet, and throttle stop screw.
Install the float valve, float, and float arm pin. Install the
float chamber.
4-3