Download Print this page

GE JKP13 Use And Care Manual: Power Outage

Built-h electric oven.
Hide thumbs


The clock must be set for the
automatic oven timing functions to
work properly. The time of day
cannot be changed during a Timed
Baking or Self-Cleaning cycle.
The timer does not control oven
operations. The maximum setting
on the timer is 9 hours and 55
To Reset the Timer
If "TIMER" is displayed, press the INCREASE or
DECREASE pad until the desired time is reached.
If "TIMER" is not displayed, press the TIMER
ON/OFF pad first, then follow the instructions
above to set the timer.
End of Cycle Tones
The end of cycle tone is 3 short beeps followed by
1 beep that repeats every 6 seconds until you press
any operation. If you would like to eliminate the
repeating beeps, press and hold the CLEAR/OFF pad
for 10 seconds.
return the signal that beeps every 6 seconds, press
and hold the CLEAWOFF pad for 10 seconds.

Power Outage

After a power outage, when power is restored, the display will flash and the
time shown will no longer be correct-for example, after a 5-minute power
interruption the clock will be 5 minutes slow. The display flashes until the
clock is reset. All other functions that were in operation when the power
went out will have to be programmed again.
To Set the Clock
1. Press the
CLOCK pad.
To Set the Timer
1. Press the TIMER ON/OFF pad.
2. Press the INCREASE or
DECREASE pad to set the
amount of time on the timer.
The timer will start automatically
within a few seconds of releasing the
The timer, as you are setting it,
will display seconds until 1 minute
is reached.
To Cancel the Timer
Press and hold the TIMER ON/OFF pad until the
word "TIMER" disappears from the display.
Display Messages
If "door" appears in the display, the door is not
closed. If "LOCK" appears in the display, the oven
door is in the locked position. BAKE, BROIL and
COOK TIME cannot be set if the door is in the
locked position.
2. Press the INCREASE or
DECREASE pad to set the time
of day.
Then it will display minutes
and seconds until 10 minutes
is reached.
After 10 minutes, it will display
minutes only until 59 minutes
is reached.
After 59 minutes, it will display
hours and minutes ("HR" now
appears in the display) until the
maximum time of 9 hours and
55 minutes is reached.


   Also See for GE JKP13

   Related Manuals for GE JKP13

This manual also for:

Jrp24, Jkp26, Jrp14, Jkp14, Jkp27, Jrp15

Comments to this Manuals

Symbols: 0
Latest comments: