To Cancel The Timer; Power Outage - GE JKP44 Use And Care Manual

Hide thumbs Also See for JKP44:
Table of Contents

Advertisement

OVEN CONTROL, CLOCK Am TMER
The clock must be set for the automatic oven timing
functions to work properly. The time of day cannot be
changed during a Timed Baking or Self-Cleaning
cycle.
Timer
The timer is a minute timer only.
The timer does not control oven operations.
The maximum setting on the timer is 9 hours and
55 minutes.
To Reset the Timer
If "TIMER" is displayed, press the INCREASE or
DECREASE pad until the desired time is reached.
If "TIMER" is not displayed, press the TIMER
ON/OFF pad first. then follow the instructions above
to set the timer.
End of Cycle Tone
The End of Cycle tone is a series of three beeps
followed by one beep every six seconds. If you would
like to remove the signal that beeps every six seconds,
press and hold the CLEAR/OFF pad for 10 seconds.
To return the signal that beeps every six seconds,
To Set the Clock
1. Press the CLOCK pad.
CLOCK
2. Press the INCREASE or DECREASE
pad to set the time of day.
3. Press the CLOCK pad to start.
To Set the Timer
1. Press the TIMER ON/OFF pad.
TIMER
ON/OFF
2. Press the INCREASE or DECREASE pad to set the
amount of time on the timer.
The timer will start automatically within a few seconds
of releasing the INCREASE or DECREASE pad. The
timer, as you are setting it, will display seconds until
one minute is reached. Then it will display minutes
and seconds until 60 minutes is reached.
After 60 minutes, it will display hours ("HR" now
appears in the display) and minutes until the
maximum time of 9 hours and 55 minutes is reached.

To Cancel the Timer

Press and hold the TIMER ON/OFF pad until the
word "TIMER" disappears from the display.

Power Outage

After a power outage, when power is restored, the
display will flash and time shown will no longer be
correct-for example, after a 5-minute power
interruption the clock will be 5 minutes slow. The
display flashes until the clock is set.
All other functions that were in operation when the
power went out will have to be programmed again.
7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jkp45

Table of Contents