Light; Bulb Replacement - GE JKP13 Use And Care Manual

Oven Shelves
Clean the shelves with an abrasive cleanser or
steel wool. After cleaning, rinse the shelves with
clean water and dry with a clean cloth.
NOTE: The oven shelves may also be cleaned
in the self-cleaning oven. However, the shelves will
darken in color, lose their luster and become hard to
slide if cleaned during the self-cleaning cycle. Wipe
the shelf supports with cooking oil to make the
shelves slide more easily.
Broiler Pan and Rack
After broiling, remove the broiler pan from the oven.
Remove the rack from the pan. Carefully pour out
grease from the pan into a proper container. Wash and
rinse the broiler pan and rack in hot water with a
soap-filled or pl&tic scouring pad.
If food has burned on, sprinkle the rack with
detergent while hot and cover with wet paper towels
or a dishcloth. Soaking the pan will remove burned
on foods.
The broiler pan may be cleaned with a commercial
Oven Light Bulb Replacement
CAUTION: Before replacing your oven light,
disconnect electrical power for your oven at the
main fuse or circuit breaker panel or pull the plug.
Be sure to let the light cover and bulb cool completely
before removing or replacing them. When cleaning,
avoid touching warm lights with cleaning cloths if the
light cover is removed.
The oven light (bulb) is covered with a removable
glass cover which is held in place with a wire. Remove
the oven door, if desired, to reach cover easily.
To remove:
Hold vour hand under the '-+_—
cover-so it doesn't fall
when released. With
fingers of the same
hand, firmly push back
the wire cover holder.
Lift off the cover.
Both the broiler pan and rack can also be cleaned
in the dishwasher.
Do not clean the broiler pan or rack in the self-
cleaning oven.
Do not store a soiled broiler pan and rack anywhere
in the oven.
DO NOT REMOVE ANY SCREWS.
Replace bulb with 40-watt home appliance bulb.
To replace cover:
Place it into the groove of the light receptacle. Pull
wire forward to the center of cover until it snaps into
place. When in place, the wire holds the cover firmly.
Be certain the wire is in the depression in the center
of the cover.
Connect the electrical power to the oven.
Wire cover holder
(continued next page)
23