Upgrade Procedures For 1.1 Ghz Mx2 Dual Processors (A9730A); Introduction; Required Tools; Back Up Your System - HP Integrity rx4640 Upgrade Manual

2
Upgrade Procedures for 1.1 GHz mx2 Dual
Processors (A9730A)

Introduction

This chapter presents procedures procedures for installing hp mx2 dual processor modules. This change
replaces the processor and updates server firmware. Included are instructions to protect your data, back up
the existing operating system (OS) software (in case of an error condition during the update), download new
firmware, and replace/install new hardware. After performing these procedures, you will be directed to start
up your server and resume operation.

Required Tools

The hp Integrity rx4640 Upgrade Kit contains some of the tools needed to perform this procedure, including
an ESD-safe workstation. Additionally, a long flat blade screwdriver is required. When performing this
upgrade, you must use a static-dissipating work surface and a wrist strap.

Back Up Your System

Before performing the server upgrade, protect yourself by backing up all data and your server OS. In the
event of interruptions (for example power failure, interference, and so on.), it may be necessary to resume
operation in the old configuration before upgrading the server.
Back Up Your Data
Back up your data in accordance with local procedures.
Back Up the Operating System
Always keep a backup copy of the current operating system (OS) available for emergency use. The OS was
provided on CD with your server. You can obtain a copy from your hp-Information Resource Center (ITRC) or
download the Windows TM or hp-UX TM OS from http://www.hp.com/support/itaniumservers.
Software/Firmware Requirements
Ensure the server meets the minimum software and firmware revisions listed below. Update as necessary.
• Management Processor (MP) firmware E.02.23
• VGA/Bus card ROM Firmware. Revision 106
• System Firmware greater than 1.13
• IPF Offline Diagnostics 0403, March 2004
Download Firmware and Shutdown the Server
To download firmware and shutdown the server, proceed as follows:
Step 1. Make sure that all users are logged off and that the server is not in use.
Step 2. Perform an orderly shutdown of the server operating system.
Step 3. Download server firmware. Current revisions of firmware and utilities, together with download
instructions are available from your ITRC and from http://www.hp.com/support/itaniumservers.
Chapter 2
31