H3C S7500E Series Installation Manual page 96

To do...
Reboot the switch or a card other
than the standby SRPU at once (in
standalone mode)
Reboot the standby SRPU (in
standalone mode)
Reboot the IRF virtual device, a
member switch, or a card (in IRF
mode)
Use one of the following commands to schedule a reboot of the switch:
To do...
Schedule a reboot of the switch at
a specific date and time
Schedule a reboot of the switch
after a specific amount of time
NOTE:
To reboot the switch or the active SRPU by using the reboot command, you must ensure that you have
•
specified a main boot file.
The switch prompts "REBOOT IN ONE MINUTE" one minute before the rebooting time and then reboots
•
in one minute.
• For data security, the switch does not run a scheduled reboot task if you are performing a file operation
at the scheduled reboot time.
Use the command...
reboot [ slot slot-number ]
slave restart
reboot [ chassis chassis-number
[ slot slot-number ] ]
Use the command...
schedule reboot at hh:mm [ date ]
schedule reboot delay { hh:mm |
mm }
85
Remarks
Available in user view.
If no slot is specified, the command
reboots the entire switch.
Available in system view.
Available in user view.
•
If neither chassis nor slot is
specified, the command
reboots all member switches.
•
If only a chassis is specified, the
command reboots the specified
member switch.
•
If you specify both a chassis
and a slot, the command
reboots the specified card in
the specified switch.
Remarks
By default, no reboot schedules are
set.
Available in user view.
By default, no reboot schedules are
set.
Available in user view.