H3C S7500E Series Installation Manual page 30

Other models: Install the cable management brackets to the mounting brackets, and then install the
•
mounting brackets to the chassis. For more information, see
brackets on other
Installing the cable management brackets on the S7506E-V
The S7506E-V has two cable management brackets—the one with a tray is installed at the lower part of
the switch, and the one without a tray is installed at the upper part of the switch. They are installed in the
same way.
Follow these steps to install a cable management bracket:
Take out the cable management brackets from the package.
Step1
Attach the cable management bracket to the chassis, and align the screws with the screw holes on the
Step2
chassis, as shown in
Fasten the screws.
Step3
Figure 12 Install cable management brackets on an S7506E-V
1: Attach the cable management bracket to the
chassis
3: Screws for fixing the cable management bracket to
the chassis
5: Cable management bracket with a tray (installed at
the lower part of the chassis)
Installing the cable management brackets on other models
For the models except the S7506E-V, install the cable management bracket on the left mounting bracket,
as shown in
management bracket screw holes is the left mounting bracket.
models" and
Figure 12.
Figure 13. The switch is supplied with two mounting brackets, and the one with the cable
"Installing the mounting
2
4
3
1
2
5
3
1
2: Screw holes for installing the cable management
bracket
4: Cable management bracket without a tray
(installed at the upper part of the chassis)
19
"Installing the cable management
brackets."