H3C S7500E Series Installation Manual page 71

NOTE:
The output may vary by software version.
Starting......
RAMLine.....OK
System is booting................
************************************************************************
*
*
*
************************************************************************
Creation Date
CPU Type
CPU L1 Cache
CPU Clock Speed
Memory Type
Memory Size
Memory Speed
BootRom Size
Flash Size
CPLD Version
PCB Version
Mac Address
Press Ctrl+B to enter Boot Menu...0
Starting to get the main application file--flash:/S7500E-CMW520-R6616.app!.....
..............................................
The main application file is self-decompressing................................
...............................................................................
...............done!OK
System is starting...
User interface aux0 is available.
Press ENTER to get started.
The output shows that the switch has been started. Press Enter and
can configure the switch. For more information about configuring the switch, see
switch."
NOTE:
After powering on the switch, check the following items:
• The cooling system is working. You should be able to hear fan rotating noise and feel air being blown
out.
All the system LEDs on the SRPUs are functioning properly. For more information about the LED status,
•
see the chapter "Appendix C LEDs."
BOOTROM, Version 3.01
: Aug 26 2010
: BCM1125H
: 32KB
: 600MHz
: DDR SDRAM
: 512MB
: 133MHz
: 512KB
: 64MB
: 002
: Ver.B
: 0000FC007506
60
displays. By this time, you
<Sysname>
"Initially configuring the
*
*
*