Horizontal Surface Mounting - HP ProCurve 10 Installation Manual

Installing the HP 10/100 Hubs
Installation Procedures
4.
install additional
screw

Horizontal Surface Mounting

Place the hub on a table or other horizontal surface. Use a sturdy surface in
an uncluttered area. You may want to secure the networking cables and hub
power cord to the table leg or other part of the surface structure to help
prevent people from tripping over the cords.
N o t e
Make sure the air flow is not restricted around the sides and back of the hub.
2-8
Install the other number 12-24 screw into the upper hole in each bracket.
Tighten these screws.