Horizontal Surface Mounting - HP OfficeConnect 1820 8G Installation And Getting Started Manual

To mount the 1820 8-port switches, follow these steps:
1. In the required location, mark the position for the mounting screws. The hole-to-hole distance is 3.54 inch
(90 mm).
2. Use a #1 Phillips (cross-head) screwdriver and two of the included 20-mm M4 tap screws. Set the screw
heads approximately 2 mm away from the mounting surface to allow the switch to slide onto the screws.
Wall anchors are included in the accessory kit for use with plastered brick or concrete walls.
1 20mm M4 tap screws
2 Wall anchors
3. For under-table mounting, a third 20-mm M4 tap screw can be placed against one side of the switch to
secure it in place.

Horizontal surface mounting

Place the switch on a table or other horizontal surface. The switch comes with rubber feet in the accessory kit
that can be used to help keep the switch from sliding on the surface.
Attach the rubber feet to the four corners on the bottom of the switch within the embossed angled lines. Use a
sturdy surface in an uncluttered area. You may want to secure the networking cables and switch power cord
to the table leg or other part of the surface structure to help prevent tripping over the cords.
1
2
Horizontal surface mounting 21