Page of 66
Download Table of ContentsContents Print This PagePrint Bookmark

HP ProCurve 10 Installation Manual: Connect The Network Cables

Switches and hubs.
Hide thumbs

Advertisement

Installing the HP 10/100 Hubs
Installation Procedures

5. Connect the Network Cables

Connect the network cables, described under "Cabling Infrastructure" (page
2-4), from the network devices or your patch panels to the RJ-45 ports on the
hub.
To connect the cables:
Push the RJ-45 plug into the RJ-45 jack
until the tab on the plug clicks into place.
When power is on for the hub and for the
connected device, the Link LED for the
port should light to confirm a powered-
on device (for example, an end node) is
at the other end of the cable.
If the Link LED does not go on when
the network cable is connected to the
port, see "Diagnosing With the LEDs"
in chapter 3, "Troubleshooting".
To disconnect:
Press the small tab on the plug and pull
the plug out of the jack.
2-10
2X
3X
4X
5X
6X
8X
9X
10X
11X
12X
RJ-45 plug
Unshielded twisted-pair cable:
• Category 3, 4, or 5 for 10 Mbps ports
• Category 5 only for 100 Mbps ports
Maximum distance: 100 meters

Advertisement

This manual also for:

Procurve 100

Comments to this Manuals

Symbols: 0
Latest comments: