Wall Mounting; Connect The Hub To A Power Source - HP ProCurve 10 Installation Manual

Wall Mounting

You can mount the hub on a wall. Note that the hub should be mounted only
to a wall or wood surface that is at least 1/2-inch plywood or its equivalent.
1. Use a #1 Phillips (cross-head) screwdriver and attach the mounting
brackets to the hub with the included 8-mm M4 screws as shown in the
illustration below.
2. Attach the hub to the wall or wood surface with two 5/8-inch number 12
wood screws (not included}.
8 mm M4 screws

4. Connect the Hub to a Power Source

1. Plug the included power cord into the hub's power connector and into a
nearby AC power source.
2. Re-check the LEDs during self test. See "LED Behavior" on page 2-5.
For power precautions, see the section, "Installation Precautions" earlier in
this chapter. The HP 10/100 hubs do not have a power switch. They are
powered on when the power cord is connected to the hub and to a power
source.
Installing the HP 10/100 Hubs
Installation Procedures
5/8-inch
wood screws
2-9