Removing The Convection Fan Motor - Whirlpool Polara GR556LRK Service Manual

REMOVING THE CONVECTION FAN MOTOR

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
NOTE: Sharp edges may be present.
1. Unplug the refrigerated range or discon-
nect the power.
2. Open the oven door and remove the racks
from inside the oven.
3. Remove the two screws and lockwashers
from the convection fan motor cover, then
unhook the bottom tab from the liner slot,
and remove the cover.
Screw &
Convection Fan
Lockwasher
Motor Cover
Cover Tab
4.
5.
6.
Screw &
Lockwasher
4-15
Use a large screwdriver or a 13 mm socket,
and remove the cap nut (clockwise) from
the convection fan, then pull the fan off the
convection fan motor shaft.
Pull the refrigerated range away from the
wall so that you can access the rear of the
unit.
Remove the two screws from the rear
panel and remove the panel (see step 5 on
page 4-13).
Convection Fan Motor
Continued on the next page.
Convection
Fan
Cap Nut