Door Latch Assembly; Control Cooling Fan Motor - Whirlpool Polara GR556LRK Service Manual

Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.

DOOR LATCH ASSEMBLY

Solenoid Terminals
Refer to page 4-10 for the procedure for servic-
ing the door latch assembly.
1. Unplug the refrigerated range or discon-
nect the power.
2. Disconnect one of the wires from the door
latch assembly component under test.
3. Set the ohmmeter to the R x 1K scale.
4. To test the solenoid, touch the ohmme-
ter leads to the terminals. The meter should
indicate between 3000 and 3800 Ω.
5. To test the door latch switch:
a) Touch the ohmmeter leads to the COM
and N.O. terminals. The meter should
indicate an open circuit (infinite).
b) With the ohmmeter leads connected as
stated in the previous step, press the
switch actuator. The meter should in-
dicate continuity (0 Ω).
WARNING
Electrical Shock Hazard
Door Latch Switch
5-3

CONTROL COOLING FAN MOTOR

Refer to page 4-18 for the procedure for servic-
ing the control cooling fan motor.
1. Unplug the refrigerated range or discon-
nect the power.
2. Set the ohmmeter to the R x 1 scale.
3. Touch one of the ohmmeter leads to the
control cooling fan motor terminals. The
meter should indicate between 55 and
75 Ω.
Motor
Terminals