Installing The System Fan 1 - Fujitsu Siemens Computers PRIMERGY TX200 S4 Server Options Manual

Completion
Ê Connect the fan cable to the connector FAN2 SYS on the system board.

13.1.4 Installing the system fan 1

Ê Install the system fan 3, the traverse and the system fan 2 before.
Figure 72: Installing the system fan 1
Ê Connect the fan cable to the connector FAN1 SYS on the system board.
Ê Insert carefully the air duct with the integrated system fan 1 using the pins
on the PSU casing and the traverse (see circles).
Ê Push the air duct to the rear side until the pins on the PSU casing and the
traverse engage. Make sure that the lock engages too.
TX200 S4
Options Guide
System fans and traverse
87