Switching On The Device (Without Main Power Switch); Installing The Software - Fujitsu Siemens Computers Primergy Econel 100 Series Operating Manual

Getting started

Switching on the device (without main power switch)

► Press the ON/OFF switch on the front of the device.
The power-on indicator lights green and the device is started.

Installing the software

Configure the server and install the desired operating system and applications.
This can be done in one of the following ways:
• Remote configuration and installation with ServerStart:
The included "ServerStart" CD makes it easy for you to configure the server
and then install the operating system.
• Local configuration and installation with or without ServerStart (see
or EasySetup", Page 23
Installation with ServerStart
► Switch the device on.
► Place the "ServerStart" CD or an installation disk in the corresponding drive.
► Follow the instructions on the screen (see
Page 23 or "Configuration without ServerStart", Page
For instructions on how to operate ServerStart and further information, refer to the
"ServerView Suite - ServerStart" manual supplied as a PDF file.
For advice on configuration, see
23. If the device is integrated into a network, the user and server details as well
as the network protocol are required during the software installation.
For further information about the device and its drivers, utilities and
updates please refer to the "Drivers & Utilities" DVD or visit our website
at "http://www.fujitsu-siemens.com/support".
18
or "Configuration without ServerStart", Page
"Configuring with ServerStart or EasySetup",
"Configuring with ServerStart or EasySetup", Page
"Configuring with ServerStart
23).
23).
A26361-K1182-Z120-1-7619, edition 3