Fujitsu Siemens Computers PRIMERGY TX200 S4 Server Options Manual page 60

Installing an expansion board
Figure 44: Removing the slot cover
Ê Remove the PCI slot cover.
V
CAUTION!
Keep the slot cover for further use. If the expansion board is removed
again and not replaced with a new one, the slot cover has to be
reinstalled to comply with applicable EMC regulations and satisfy
cooling requirements and fire protection measures.
Ê Unpack the new expansion board, and make the desired settings. You
should read the accompanying documentation supplied with the expansion
board beforehand.
Ê Install the expansion board into the PCI slot and press it carefully into the
associated plug-in location on the system board until it engages properly.
Ê Close the slot locking bar and press on the two green locking levers at the
server's rear side until they engage.
Ê If required, connect the cables to the expansion board and other compo-
nents.
60
Expansion boards in the PCI slots
Options Guide
TX200 S4