Using The Computer Setup (F10) Utility To Reset Cmos - HP xw4550 Service And Technical Reference Manual

Using the Computer Setup (F10) Utility to reset CMOS

1. To reset CMOS using the Computer Setup (F10) Utility, access the Computer Setup (F10) Utility
menu. When the Computer Setup message appears in the lower-right corner of the screen, press
the F10 key. Press Enter to bypass the title screen, if necessary.
NOTE:
powered off, then on again, to access the utility.
2. From the Computer Setup (F10) Utility menu, select File>Set Defaults and Exit. This restores the
soft settings that include boot sequence order and other factory settings. It does not, however,
force hardware rediscovery.
NOTE:
system date and time.
138 Chapter 6 Configuring password security and resetting CMOS
If you do not press the
You must reset the workstation passwords and any special configurations, along with the
F10 key while the message is displayed, the workstation must be
ENWW