Pci - HP xw4550 Service And Technical Reference Manual

PCI

To remove a PCI card:
1. Disconnect power from the system
access panel
on page
2. Lift the PCI levers (1) by first pressing down and then up.
3. Lift the PCI card (2) out of the chassis. Store the card in an anti-static bag.
4. Install a PCI slot cover and close the PCI levers. If the PCI levers do not close, be sure all cards
are properly seated and then try again.
Figure 4-24
To install a PCI card:
1. Disconnect power from the system
access panel
on page
2. Lift the PCI levers (1) by first pressing down and then up.
3. Remove the PCI slot cover (2).
4. Lower the PCI (3) card into the chassis. Verify that the keyed components of the card align with
the socket.
78 Chapter 4 Removal and replacement procedures
(Side access panel on page
75), if installed.
Removing the PCI card
(Side access panel on page
75), if installed.
(Predisassembly procedures on page
62), and remove the PCI retainer
(Predisassembly procedures on page
62), and remove the PCI retainer
57), remove the side
(PCI retainer
57), remove the side
(PCI retainer
ENWW