Restoring The Windows Xp Professional Operating System; The Restoreplus! Process; Creating A Restoreplus! Cd; Restoring From Restoreplus! Cds - HP xw4550 Service And Technical Reference Manual

Restoring the Windows XP Professional operating system

Your workstation has several methods to restore your Windows XP operating system to a near-factory
state, or to the state of the system at a predefined snapshot in time. Your system has a recovery partition
on the system hard drive that contains software and data required for the restore process as described
in the following sections.

The RestorePlus! process

The Windows operating system and device drivers (for devices shipped with the system) are reinstalled
using this process. Some application software may not be restored using the RestorePlus! process. In
this case you must install the application software from the appropriate application CD. The RestorePlus!
process can be executed from CD or from the recovery partition contained on your system hard drive.
CAUTION:
Windows partition will be deleted when you restore using the RestorePlus! process. However, the
recovery partition on the system drive and other partitions should not be affected.

Creating a RestorePlus! CD

You can create a set of the CDs from your system if you have a CD writer. When you first boot your
system, you will be prompted to make CDs for RestorePlus!, the Windows operating system, and a
supplemental HP Backup and Recovery Manager CD. (There may be additional CDs you can create
depending on the options you purchased.) You also have the option to move images of the CDs to
another location, such as a network share, to be written to CD at a later time or from another system.

Restoring from RestorePlus! CDs

The RestorePlus! process can be started by powering up from the RestorePlus! CD.

Restoring from RestorePlus! on the Recovery Partition

Follow these steps to start the RestorePlus! process from the Emergency Recovery menu:
1. Boot the workstation.
2. Press F11
F11 prompt appears briefly during the boot process.
If you have a recovery partition but the F11 prompt is not visible:
a. Press
b. Select Advanced from the drop down menu.
c. Select Power-On Options.
d. Ensure that the F11 prompt is set to Displayed.
e. Ensure that Factory Recovery Boot Support is set to Enabled.
f. Reboot the workstation and press
3. Select Recover PC's factory installed operating system, drivers, utilities, and applications
from the Emergency Recovery menu.
NOTE: Some applications might not be restored using this method.
20 Chapter 2 Configuring and restoring the operating system
Back up your data before you attempt any operating system restore. All data on the
when prompted during the boot process to enter the Emergency Recovery menu. The
F10 to access the setup menu.
F11 when prompted.
ENWW