HP xw4550 Service And Technical Reference Manual page 36

Table 3-1 Computer Setup (F10) Utility menu descriptions (continued)
Heading
Storage
SATA defaults
28 Chapter 3 System management
Option
About Displays copyright information.
Set Time and Enables you to set system time and date.
Date
Flash System CD-ROM – Enables you to upgrade the BIOS from a ROM image on CD.
ROM
NOTE: Optical drives must be in Legacy or Native mode.
USB – Enables you to upgrade the BIOS from a ROM image on a USB drive or memory stick.
Replicated Save to Removable Media
Setup
Saves the system configuration, including CMOS, in the QSETUP.TXT file. This file can be saved
to a formatted, blank 1.44-MB diskette or to a USB-connected storage device.
Restore from Removable Media
Restores system configuration from a diskette.
Default Setup Save Current Settings as Default
Saves the current settings as default settings for the next operation.
Restore Factory Settings as Default
Restores the factory settings as the default settings for the next operation.
Apply Defaults Restores factory default settings.
and Exit
Ignore Changes Exits the computer setup without applying or saving any changes.
and Exit
Save Changes Saves changes to system configuration and exits the computer setup.
and Exit
Device Lists all installed non-SCSI storage devices and provides options for getting specific information
Configuration about each device.
Hard Disk
Provides information about the hard disk drives in the system.
CD-ROM
Provides information about the optical drives in the workstation.
Diskette Type (for legacy diskette drives only) identifies the highest capacity media type accepted
by the diskette drive. Options are 3.5" 1.44 MB, 5.25" 1.2 MB, and Not Installed.
Restores or Default Values
resets SATA
Resets devices to their SATA default configuration.
defaults
Multisector Transfers options are 8, 16, and Disable; 16 is default.
Transfer Mode specifies the active data transfer mode. Options (subject to device capabilities) are
Max UDMA, PIO 0, Max PIO, Enhanced DMA, and Ultra DMA0; Max UDMA is default.
Translation Mode enables BIOS to automatically determine the translation mode used to configure
a previously formatted SATA or USB mass storage device. This prevents you from having to know
how the mass storage device was previously formatted.
Description
ENWW