Using The Computer Setup (F10) Utility; Computer Setup (F10) Utility Menu - HP xw4550 Service And Technical Reference Manual

Using the Computer Setup (F10) Utility

You can only open the Computer Setup (F10) Utility by powering on the workstation or restarting the
workstation. To access the Computer Setup (F10) Utility menu:
1. Power on or restart the workstation.
2. Press the
right corner of the screen.
NOTE: If you do not press
on, and press
you miss the opportunity to press F10.
3. Select your language from the list and press the
menu, five headings are displayed: File, Storage, Security, Power, and Advanced.
4. Use the arrow (left and right) keys to select the appropriate heading. Use the arrow (up and down)
keys to select the option you want, and press Enter.
5. To apply and save changes, select File>Save Changes and then select F10=YES.
●
If you have made changes that you do not want applied, select Ignore Changes and then
select F10=YES.
●
To reset to factory settings, select File>Default setup>Restore Factory Settings as
Default. Press
restores the original factory system defaults.
CAUTION: Do not power off the workstation while the ROM is saving your Computer Setup (F10)
Utility changes because the Complementary Metal-Oxide Semiconductor (CMOS) could become
corrupted. After you exit the F10 Setup screen, it is safe to disconnect power from the workstation.

Computer Setup (F10) Utility menu

NOTE: The following content is subject to change with new BIOS releases, so your menu might be
different than shown.
Table 3-1 Computer Setup (F10) Utility menu descriptions
Heading
File
ENWW
F10 key as soon as your display is active and you see F10=Setup appear in the lower
F10 at the appropriate time, try again. Turn the workstation off, then
F10 again to access the utility, or press the
F10 to accept the changes. Select Apply Defaults and Exit. This option
Option
System Lists:
Information
● Product Name
● SKU Number
● Processor Type/Speed/Stepping
● Cache Size (L1/L2)
● Installed Memory Size
● Integrated MAC
●
System BIOS
●
Chassis Serial Number
●
Asset Tracking Number
Ctrl + Alt + Delete
Enter key. In the Computer Setup (F10) Utility
Description
Computer Setup (F10) Utility
keys before boot if
27