Bezel Blanks; Optional Hood Sensor (Smart Cover Sensor) - HP xw4550 Service And Technical Reference Manual

Bezel blanks

To remove the bezel blanks:
1. Disconnect power from the system
bezel (Front Bezel on page
2. Gently push the subpanel (1) out the back of the front bezel.
3. Remove the desired bezel blank by applying outward pressure on the subpanel (1) and pulling the
blank (2) away.
Figure 4-7
NOTE: The bezel blanks are keyed to assist you in replacing the blanks. Also, the subpanel can be
rotated 90 degrees to install the optical drives in desktop orientation if desired.

Optional hood sensor (Smart cover sensor)

To remove the optional hood sensor:
1. Disconnect power from the system
access panel
64 Chapter 4 Removal and replacement procedures
63).
Removing the bezel blanks
(Side access panel on page
(Predisassembly procedures on page
(Predisassembly procedures on page
62).
57) and remove the front
57) and remove the side
ENWW