2. AC Smart II Installation
Setting unit address
First, you must assign the address to each unit so that the address of each unit (Indoor unit, ventilator,
Eco V DX , On/Off, AWHP) is not duplicated by considering the overall installation composition
connected to AC Smart II.
The address of the unit can be set in hexadecimal from 00 to FF.
Caution: Setting address for indoor unit, ventilator, On/Off unit and
AWHP unit
You cannot set the same address for the indoor unit, ventilator, Eco V DX, On/Off unit
and AWHP. Make sure not to have duplicate addresses.
The following is an example of assigning the address to the unit.
AC SMART II
Reference: Setting address for device
When setting the address of a unit (Indoor unit, ventilator, On/Off
unit, AWHP unit), it is recommended to set the first digit as the
group number, and second as unit number for easy identification.
2-3
AC Smart
Air conditioner
outdoor unit
PI485
Ventilator
PI485
On/Off unit
AWHP Outdoor unit
PI485
Indoor unit 1
Indoor unit 2
AWHP Indoor unit
Indoor unit 3
00
00
Group
Group
Unit
Unit
number
number
number
number