Creating Operating Group - LG V-NET AC Smart II Advanced Control Smart Owner's Manual

Managing operating group
In auto control, you must create/apply each group for the temperature limit operation, auto change
over operation and time limited operation.
Reference: Temperature limit operation and auto change over
operation group setting criteria
Temperature limit operation and auto change over operation are functions targeted only to the
indoor units. Therefore the Group can only be created or edited for the indoor units, and cannot
Indoor unit, ventilator, Eco V DX, On/Off, AWHP.
Reference: Auto changer over operation group setting
If the outdoor unit is not a changer over type and not a synchronized type, always set one outdoor
unit to the connected indoor units to form a group when setting the auto change over operation. If
not, it can cause irregular operation. (CH 07 error)
This describes the method of creating/renaming/deleting the Group for the example of time limit
operation. You can create/rename/delete the Group in the same way for temperature limit operation
and auto change over operation as well.

Creating operating group

To create a new operating Group, proceed as follows.
1
. Press the [Edit group] button located at the bottom of the ʻAuto controlʼ screen.
Press the [Edit group] button
Installation/Owner's Manual
6. Auto control menu
6-2