Line Connecting Section; Operation Panel - Konica Minolta FK-502 Service Manual

1. OUTLINE OF THE DEVICE
1.1.4

Line connecting section

NCU type
Connecting terminal
Modem
Modem sending level
DTMF sending level
Receiving sensitivity
Dialing signal
1.1.5

Operation panel

FAX / copy / scan / box
Interruption during
scanning
Interruption during
recording in the FAX
mode screen
FAX start
Stop
FAX free memory
display
File existence
indication
Display during the FAX
communications
Error display
Time display
Remote station ID
display
Other operation
buttons
4
A-A~ and built-in NCU
RJ11
Matsushita MMD-H5005
-10 to -15 dBm (Country spec)
-10 to -15 dBm (Country spec)
G3 reception: up to -48 dB
Tone reception: up to -52 dB
DP (10pps) and DTMF
Mode switching
Initial screen after
power-on
When pressing the interrupt button while scanning documents to be transmit-
ted, INTERRUPT LED blinks. Copy screen appears after scanning is com-
pleted.
Operations by using the interrupt button are invalid.
by using the start button.
by using the stop button.
• Possible to appoint to stop from the job list so as to stop during operations
of the multi jobs.
RDH memory
• % indication on LCD during scanning, recording and stand-by.
File memory (RAM disk/HDD)
• Display in the JOB LIST screen
In the following cases, the data Indicator (LED) on the control panel lights up.
• Upon reception of FAX
• When a document is saved in the bulletin board box, polling TX box, and
memory RX user box.
Icons are not displayed on the FAX waiting screen and the FAX operation
screen.
Displayed by LCD panel
Date and time displayed.
• Present time is displayed on the sub-area.
Yes
• The TSI/CSI display during communications
[Scan Setting], [Comm. Setting] key: Moves to the FAX application function
setting screen.
Mode Check button: Valid
*/# button: Yes
Help button: Yes
Field Service Ver. 9.0 Jan. 2010
by panel key selection
• Possible to change modes during an operation
of each mode.
• No mode return by the auto reset.
Screen at power off or facsimile screen.
(depending on parameter setting)