Using The Management Utility - Billion MWEB W40 Quick Start Manual

Using the Management Utility:

1. Run the Utility software by launching it from the "Start>All programs>MWEB W40" menu.
See figure below:
2. The MWEB W40 management utility will launch and immediately prompt you for a router IP address
and password (see figure below):
This information is used to access the router. If you have not intentionally altered the IP address of the
router, it will still be 192.168.1.254, which is the factory default.
The password is the administration password that you might have changed during the final step of
the Easy Setup Wizard. (Please refer to step 12 on page 12). If you have not changed it
intentionally, it should still be "admin".
Once you have entered/confirmed the correct IP address and password, click the "OK" button. The
utility will now attempt to set up communications to the MWEB W40 using the information provided.
MW/W40 V4.0A-090115
Quick Start Guide
Page 14