Billion MWEB W40 Quick Start Manual page 10

8. On the Diagnostics test screen (see figure below), four tests will be performed to determine
the current status of your MWEB W40 router. These tests include:

Testing the network connection to your MWEB W40

Testing ADSL Synchronization

Testing a PPP connection

Testing a limited Internet connection using the MWEB guest account
Click on the "Diagnose" button to start the test. Should any of the four tests fail, you will be notified
of the specific failure and assisted in correcting the fault. Please follow the instructions carefully in
order to rectify any possible problems. On passing all four tests, the wizard will proceed to the next
step: Telkom Line Verification.
9. If your line is verified, the easy setup wizard will continue to the next step. If not, the Telkom
Line Verification step will help you verify your ADSL service on the live Telkom ADSL verification
webpage. Please follow the instructions on the webpage as opened in the frame on the right hand
side of the form. See figure below – the red block indicates the Telkom webpage frame. On
MW/W40 V4.0A-090115
Quick Start Guide
 If your network connection was already setup to obtain its IP
address automatically, you computer might have already
established communications with the MWEB W40 router and the
wizard might have skipped directly to the Diagnostics step.
 For advanced users: If you do not wish to use the automatic
network card setup step and you want to use a static IP scheme,
please make sure that your network connection is setup in the
correct IP range. Note that the MWEB W40 has a default IP
address of 192.168.1.254, so your computer needs to be setup in
the following range 192.168.1.x. Also setup your default gateway
and DNS server to point to the IP address of the W40.
Page 10