Connecting The Telephone; Connecting The Telephone Cable - H3C VG 31-08 Installation Manual

Installation Manual
H3C VG 31-08 Voice Gateway
Step 1: Insert one end of the Ethernet cable to the Ethernet port
of the VG 31-08 and connect the other end to a hub, an Ethernet
switch, or a router.
Step 2: Check that the LINK LED on the front panel is ON. ON
means the network cable is correctly connected.

3.6 Connecting the Telephone

The VG 31-08 can connect dual-tone multi-frequency (DTMF)
phones through its eight telephone ports. You may simply connect the
FXS ports of the VG 31-08 with the telephone through the telephone
cable.
 Note:
You are recommended to set the telephone to DTMF mode, as the VG
31-08 does not support pulse dialing; otherwise, you cannot place
calls with the telephone.

3.7 Connecting the Telephone Cable

The cables used for connecting FXO ports are telephone cables
with ferrite bead and RJ-11 connectors at both ends. You can simply
connect the VG 31-08 to a PBX through the telephone cable.
Chapter 3 Installing the VG 31-08
3-7