Canadian Application
H.2 AC Power Connections for Canadian Applications
For Canadian applications, an AC terminal block is supplied standard with the MS-9050UDC. The
AC terminal block is factory installed on the bottom left of the circuit board chassis.
CAUTION! Turn off all power (AC & DC) before making any connections.
Refer to the following illustrations for location and wiring information.
AC Terminal Block
206
FACP Chassis
AC Hot
AC Ground
AC Neutral
Figure H.3 AC Terminal Block Connections
CAUTION! Make certain that all
power (AC & DC) has been turned
transformer
connections
off before making any connections.
Connect wires from AC main to
terminal block as shown.
Ground wire to FACP backbox Earth Ground stud
MS-9050UD Series PN 52413:D 12/15/08