Important Notes - Wincor Nixdorf BEETLE /M-III User Manual

Opening the device or handling boards fitted with ESDs, you must observe
the following aspects under all circumstances:
You must always discharge yourself (e. g. by touching a grounded

object) before working with boards containing ESDs.
The equipment and tools you use must be free of static charges.

Pull out the power plug before inserting or pulling out board

containing ESDs.
Always hold boards with ESDs by their edges.

Never touch pins or conductors on boards fitted with ESDs.


Important Notes

The modular POS system BEETLE /M-III conforms to the current safety
standards for data processing equipment.
If this device is taken from a cold environment into the operating

room, moisture condensation may form. The device must be absolute-
ly dry before being put into service; an acclimatization period of at
least two hours must therefore be observed.
This device is equipped with a safety-tested power cable and may be

connected only to a prescribed grounded-contact power socket.
When setting up the device, ensure that the power socket on the de-

vice and the grounded-contact power socket are easily accessible.
To disconnect the device from the supply voltage completely, switch

off the device and disconnect the power plug of the power supply.
You can connect or disconnect USB devices during operation of your

BEETLE, provided that these devices comply with the specifications ac-
cording to usb.org. Other peripheral devices (such as PoweredUSB
printer) should be connected to or disconnected from your BEETLE sys-
tem only after the BEETLE has been switched off.
2
Expansion cards with electrostatically sensitive devices (ESD) may
be marked with this sticker.
BEETLE /M-III User Manual