Jungheinrich DFG 660 Operating Instructions Manual page 96

6.2.1 Starting procedure for the DFG
Procedure
•
• Insert the key in the key switch (68) and
turn it to the "2" position.
• The pre-heat indicator lamp lights up and
goes out automatically as soon as the
required
seconds) has been reached.
• All the indicators light up briefly to test
operation.
Z
All the indicators except for the engine oil
pressure display, parking brake indicator,
indicator lamp for neutral position and
charge current indicator (163) should go
out after a short while. If not, stop the start-
up process and rectify the fault.
•
• Turn the key to position "3".
Z
Only apply the starter for a maximum of 15
seconds without interruption. The truck is
equipped with an immobiliser which
prevents it from starting again while the
engine is running.
• Release the key as soon as the engine
starts. The key automatically reverts to the
"2" position.
Z
All indicators lights except for neutral
position and parking brake should go out
as soon as the engine starts. If not, stop
the engine immediately and rectify the
fault.
Truck ready for operation.
pre-heat time (approx. 4
163
68
3
68
97