Jungheinrich DFG 660 Operating Instructions Manual page 111

Tilting the mast forward / backward
Requirements
– Truck prepared
"Preparing the truck for operation" on
page 96).
Procedure
• Pull back on the lever (61). The mast tilts
back.
• Push forward on the lever (61). The mast
tilts forward.
The mast is now tilted back or forward.
Z
When the end stop for the operation has been reached (there will be a noise from
the pressure limitation valve) release the lever. The lever will revert automatically to
the neutral position.
Depositing a load unit (SOLO-PILOT)
Procedure
• To place the load in a horizontal position: Press the lever (61) in direction (A).
• To position the load at the correct height: Press the lever (169) in direction (A or B).
• To lower the load: Press the lever (169) in direction (A).
Z
When you reach the limit position return the control lever to its home position.
Fork adjustment (SOLO-PILOT)
Procedure
•
• To adjust the fork to the width of the load:
• Wider fork spread: Press the lever (62)
in direction (A).
• Narrower fork spread: Pull the lever
(62) in direction (B).
• To move both fork tines at the same time:
• Right: Press the lever (63) in direction
(A)
• Left: Pull the lever (63) in direction (B)
112
for operation, (see
61
A
B
62
A
B
56
63