Jungheinrich DFG 660 Operating Instructions Manual page 114

Twin operation
Requirements
– To prepare the truck for operation, (see
"Preparing the truck for operation" on
page 96)
Procedure
• To lower the load handler and tilt the mast
forward at the same time, push the Multi
Pilot forward and to the right.
• To lift the load handler and tilt the mast back
at the same time, push the Multi Pilot back and to the left.
• To lower the load handler and tilt the mast back at the same time, push the Multi
Pilot forward and to the left.
The mast is now tilted back / forward.
CAUTION!
To raise the load safely, set the fork tines as far apart from each other as possible
and centrally to the truck. The load centre of gravity must lie centrally between the
fork tines.
Fork adjustment (MULTI-PILOT)
Procedure
• Adjusting the fork makes it possible to set
the fork for the width of the load.
Wider fork spread: Press the control button
(62) in direction (2).
Narrower fork spread: Press the control
button (62) in direction (1).
Sideshifter (MULTI-PILOT)
Procedure
Z
The references to left and right are based on
load lifting as viewed from the operator's
position.
• Sideshifter left: Press the control button (63)
in direction (L).
• Sideshifter right: Press the control button
(63) in direction (R).
With MULTI-PILOT control, adjusting and
reaching are simultaneous
L
63
R
62
115